Plenty of parts here including Mag Catch looks like a complicated piece to make. Part Sheet metal a pin & machined piece. Would probably require at least 3 drawings for manufacture.
__________________ "When everyone carried Guns people were polite"
"Never attribute to malice, What can be adequately be explained by stupidity."
Stats: Online
Elefantener
Private
Joined: August 14 2012 Posts: 2
Posted: August 14 2012 at 11:45pm | IP Logged
Where did you find this?
Status: Offline
Sagittarii
SM
Joined: January 03 2011 Location: Australia Posts: 470
Posted: August 15 2012 at 8:50am | IP Logged
In my web wanderings a site had them as individual drawings.
Using Acrobat Pro I downloaded the Directory page then just pulled the rest in as "append web page".
No idea why there was no Mag Catch I was thorough checking what was available.
Stats: Online
Sagittarii
SM
Joined: January 03 2011 Location: Australia Posts: 470
Posted: August 17 2012 at 4:57pm | IP Logged
Spent some time trying to work out measurements from scale at bottom by using measuring tools in Adobe. As near as I can figure each one inch division works out to be around 2.03 to 2.06 cm that is roughly 0.78 to 0.80 inches I dropped a quarter inch grid over it and did a screen capture, that you can right click on then save to print out. If you draw up a 0.30 inch grid (20% larger) you should be able to draw it into the squares to size it. If you know some one that uses CAD even better.
Original web site for drawings was on bottom of plan pages. here it is use copy & paste into browser
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum
x 5
