Joined: May 16 2016 Location: United States Posts: 1
Posted: May 16 2016 at 3:19pm | IP Logged
Can anyone assist me in welding a Bren back together for a semi auto piece. Ajig would be nice or plans for bulding a jig would be second. if nothing more than dimensions are available I'm happy to take it from there. Thanks in advance.
Joined: April 13 2007 Location: United States Posts: 3355
Joined: August 05 2017 Location: United States Posts: 1
Posted: August 05 2017 at 8:22am | IP Logged
This would make it a lot easier:
These were recently imported with alternative demilling approval.
The critical relationships between the locking shoulder, barrel nut, magazine housing, feed ramp, ejector, and barrel have been maintained. This is an ideal piece to start or save a difficult BREN project or repairing an old re-welded BREN.
The rear 5” of receiver has been cut away. There is approximately 3/8” of material behind the locking shoulder. The locking shoulder is present and looks to be in good condition.
The front 8” of the receiver has also been cut away.
Joined: February 26 2013 Location: United States Posts: 3866
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum