For those of us lacking the equipment and skills, where can we find 07’s that will weld a cut receiver? For a 4-cut, saw-cut receiver, how much should a customer expect to pay? Is a saw cut receiver worse to deal with than a torch cut, or better (assuming the guy that did it was not a maniac)?
Status: Offline
Mr.BCH
Level 3 Site Sponsor
Joined: February 18 2006 Location: United States Posts: 879
Posted: January 28 2008 at 9:00pm | IP Logged
Do you have any pics of your receiver? I am not familiar with saw cuts. I have a few torch cuts. I'd pick saw cut but then my torch cuts missed all important featuers and they are only 3 cuts, so.... depends.
Where are you located? Were you looking to just send it out and have the work completed for you and sent back? Let us know....
x 1
Status: Offline
www.Prussia.us
E-3
Joined: October 03 2007 Posts: 16
Posted: January 29 2008 at 5:16pm | IP Logged
I am in Central New York. I have not bought the saw cut receiver yet, I figured it would wise to check with the experts, you guys, first.
I would need to farm out the welding work b/c I cannot do it, I wish I could but for health reasons I cannot.
I picked up a nice parts kit from Brian at BRP, they have them again, who knowsfor how long? If you know anyone looking, there may not be another chance it these. I do not work for BRP or anything, I just love my kit.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum
